User's Manual

IDENTIFICATION
Installation
ID ISC.ANT1520/700-HPDA/-HPDB
FEIG ELECTRONIC GmbH Page 52 von 92 ID ISC.ANT1520700-HPDA-B
User Manual_M61113-0e-ID-
E.doc
Assign
LED Bus Address 11 to an-
tenna 1.
LED Bus Address 12 to an-
tenna 2.
......... and so on.
„True“ means: LED with Bus
Address 11, 12, 13, 14 will
be active if the reader read a
valid transponder on the
corresponding antenna
7
Set by clicking on „Apply“.
8
Transponder
If the alarm should occur by
a transponder with valid AFI
byte, you have to configure
the reader as follow:
ISO-15693 – Selection Mask
Set “Enable AFI”
Set the value for the AFI in
field “AFI1” (e.g. 01)
Note:
Up to four different AFI
values could be set.
9
Operating Mode
If the alarm should occur by
an EAS, you have to
configure the reader as
follow:
Set “EAS”
10
Set by clicking on „Apply“