User's Manual

IDENTIFICATION
Installation
ID ISC.ANT1520/700-HPDA/-HPDB
FEIG ELECTRONIC GmbH Page 70 von 92 ID ISC.ANT1520700-HPDA-B
User Manual_M61113-0e-ID-
E.doc
„True“ means: LED with
Bus Address 11, 12, 13, 14
will be active if the reader
read a valid transponder on
the corresponding antenna
7
Set by clicking on „Apply“.
8
The sensitivity of the
connected radar modules
could be set in
-Peripheral Device
Commands
-People Counter
-at Busaddress 1,2 and 3
-Byte 11:
00 = Low
05 = Middle
0A = High
0F = Very high (Default)
First “Read” out actual
setting of sensitivity.
If needed change to new
sensitivity by “Write” the
new value into the GPC.
A “People Counter Reset”
command must be sent to
confirm the change,
otherwise the sensitivity will
not change.
Test: People Counter
9
Select „Commands“
10
Select Command
- „Get Reader Info“
- Peripheral Devices
11
Confirm with „Send“
Number of Devices should
be 1
1.
2.