User Manual

OBID

i-scan

UHF

Installation

ID ISC.LRU3000/3500

FEIG ELECTRONIC GmbH Page 23 of 32 M21016-3e-ID-B

Green Yellow Red Description

Configurations-Reset:

FLASH FLASH FLASH

While T1 is pushed and hold for maximal 5s

(light in sequence)

ON ON ON

After T1 has been pushed and hold for 5s. Configuration

Reset has been finished.

Input / Output LED (yellow):

Configurable LED. Can display the status of a digital input or output

ANT 1 – 4:

Green

HF Power switched on

Blue

Tag-Detect

Red

Antenna impedance error (> 50Ohm or <50Ohm)

5.2. Reset Push Buttons

Figure 19 shows the position of the reset push button’s T1 and T2.

At the right side of the connector X6 the push button T2 is positioned. With this push button a CPU-

Reset can be performed.

With the push button T1 within the reader housing on left side of X3 a complete con-

figuration reset can be performed. For performing a reset you should use a pa-

per clip and push the button T1 for at least 5 s until the 3 status LED’s (left

side) are switched on continuously, see 5.1. Status LEDs

Table 12: Configuration of the LEDs

Figure 19: Position of the reset-switches T1 and T2