Installation Manual

IDENTIFICATION Installation ID ISC.M02.M8

FEIG ELECTRONIC GmbH Page 9 of 16 M02M8-IM-e_02.doc

3.2.3 Connection of the external antennas

Up to 8 external antennas can be connected.

For the connection of the external antennas 8 antenna connectors (X1..X8 respectively A1..A8) are

available.

The connector type is U.FL-R-SMT from the company Hirose. .

Alternatively a 16pin connector can be used for the connection of the antennas.

Figure 1 shows the pin assignment.

Figure 1: Antenna connector‘s

Note:

 A coaxial cable, U.FL-LP-088, is used to connect the antenna. The antenna cable should

be no longer than 1 m. The use of other cable length are possible after consulting the

manufacturer.

 The input impedance for the antenna must be calibrated to a value of









3°).

 A not correct tuned antenna can destroy the reader.

 The optimum working quality of the antenna should be in a range of QB = 10...20.

For measuring the working quality the antenna must be connected with a 50



-source,

e.g. a network analyzer or a frequency generator

 When connecting an antenna, ensure that it does not exceed the permissible limits pre-

scribed by the national regulations for radio frequency devices.

 The ultraminiatur coax connector can be used for up to about 20 connection cycles. For

the disconnection the „Extraction Tool“ must be use according to the recommendation

from the manufacturer.