Manual instruction

20
en
Mounting the extension (ASW 18-30 PC (**)/ASW 18-45 PC (**)/
ASW 18-60 PC (**)) (optional accessory) (figure 9).
Loosen the clamping sleeve with the hook
wrench and remove the angle head.
Fasten the motor-shaft extension.
Mount the extension and lock it using the
hook wrench.
Slide the locking sleeve into the extension
and mount the connector onto the motor-
shaft extension.
Clean the threaded surface with a soft cloth
and a degreasing solvent. Apply retaining
compound to the threads.
Pay attention that the threads are grease-
free before applying the retaining com-
pound.
Mount the angle head onto the extension and
lock the clamping sleeve using the hook
wrench.
Additional information: Further information
on replacement of the output can be found
on the Internet under www.fein.com.
1.
2.
3.
6.
7.
8.
10.
11.
M = 15-20 Nm
9.
9.
9.
3/8”
1/2”
Fig. 9
Angle head
Motor-shaft extension
Clamping sleeve
Hook spanner
Extension
Locking sleeve
Connector
5.
4.
6 29 08 014 00 0