Manual instruction

Working instructions.

Before mounting or replacing application tools or accessories, remove the bat-

tery. This preventive safety measure rules out the danger of injuries through

accidental starting of the power tool.

Do not use accessories not specifically intended and recommended for this power tool by FEIN.

The use of non-original FEIN accessories can lead to overheating of the power tool and destroy

it.

For each job, use only the FEIN application tool released and intended for the

respective application.

Switching on and off (figure 13).

Always hold the power tool

firmly. Otherwise, you could

lose control over the power tool.

The power tool is equipped with a soft-start-

ing feature.

If the motor switches off after a proper

screwdriving operation, restarting is not pos-

sible until after 0.8 seconds. This prevents

accidental retightening of already tightened

screws.

In left rotation mode, the

power tool switches off with

significantly increased torque. Before putting

into operation, set the torque within the

specified limits on a suitable test bench.

Switching on:

When pressing the On/Off switch halfway in,

the light goes on.

When pressing the On/Off switch completely

in, the light and the power tool are on.

Switching off:

To switch off the power tool, release the

On/Off switch.

The machine switches to the Energy Saving

Mode approx. 30 min after the last actuation

of the switch. The machine is reactivated by

actuating the On/Off switch.

WARNING

CAUTION

ASW 18-18 PC (**)/ASW 18-30PC (**)/

ASW18-45 PC (**)/ASW 18-60 PC (**)/

ASW 18-6 PC (**)/ASW 18-12 PC (**)

ASM18-3PC (**)/ASM18-8PC (**)/

ASM18-12PC (**)

Fig. 13