Manual instruction

23
en
For your safety.
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed “General
Safety Instructions” (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
BLS (**): Hand-guided sheet metal shears for cutting
sheet metal in weather-protected environments with-
out water supply using the application tools and acces-
sories recommended by Fein.
BSS (**): Hand-guided slitting shears for cutting sheet
metal and tight curves in weather-protected environ-
ments without water supply using the application tools
and accessories recommended by Fein.
This power tool is also suitable for use with AC gener-
ators with sufficient power output that correspond to
the Standard ISO 8528, design type G2. This Standard
is particularly not complied with when the so-called dis-
tortion factor exceeds 10 %. When in doubt, please
refer to the generator instruction/specification guide.
Character Unit of measure-
ment, international
Unit of measure-
ment, national
Explanation
P
1
W W Power input
P
2
WWOutput
n
0
/min, min
-1
, rpm,
r/min
rpm Stroke rate at no-load
n
S
m/min m/min Cutting speed
U VVRated voltage
f Hz Hz Frequency
M... mm mm Size of metric thread
Ø mm mm Diameter of a round part
mm mm Max. work-piece thickness for steel with up to
400 N/mm
2
mm mm Max. work-piece thickness for steel with up to
600 N/mm
2
mm mm Max. work-piece thickness for steel with up to
800 N/mm
2
mm mm Max. work-piece thickness for aluminium with up
250 N/mm
2
mm mm Diameter of pilot-drill for inside cut-outs
mm mm Min. inside curve radius
kg kg Weight according to EPTA-Procedure 01
L
pA
dB dB Sound pressure level
L
wA
dB dB Sound power level
L
pCpeak
dB dB Peak sound pressure level
K... Uncertainty
m/s
2
m/s
2
Vibrational emission value according to EN 62841
(vector sum of three directions)
h
m/s
2
m/s
2
Vibrational emission value
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
Basic and derived units of measurement from the
international system of units SI.
Fe 400
Fe 600
Fe 800
Al 250
WARNING