User guide

(E) REV 02/03//05
ASSEMB LY I NST R UCT I ONS FOR F1942/5
MUR R AY FEI SS
©M UR R AY FEI SS I M PO RT LL C.
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
 Carefully unpack and identify all parts
before assembly. Bulbs are not included.
1. Carefully thread fixture wire and ground 
 wire through fixture loop. Screw fixture 
 loop onto top threaded pipe until secure.
2. Spread open all arms so they are spaced 
 evenly to each other.
3.  Lower arm assembly:
 A. Straighten lower arms in upright  
 position as shown in diagram.
 B. Install rest of lower arm onto center 
 body by fastening with machine screw 
 from inside. Tighten with enclosed hex 
 key.
 C. Screw threaded stud into a finial.
 D. Install cap onto center body by  
 fastening with finials from top and  
 bottom.
 E. Install lower arms onto bottom of  
 upper arms by fastening with cap screw.
4. Install shades onto fitters by fastening 
 counter rings onto threaded sockets.
5. Install bulbs (not included). See  
 relamping label located at socket area 
 for type and maximum allowed wattage.
6. Follow enclosed “Chain Suspended
 Fixture Installation Instructions” for
 electrical and fixture installation onto
 ceiling outlet box.
Bulb
(not included)
Counter Ring
Glass
Shade
Fixture Wire
& Ground Wire
Lower Arm
Fixture Loop
Upper Arm
Fitter
Cap Screw
Finial
Center Body
Threaded Stud
Cap
Hex Key
Machine Screw
Finial