Instruction Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT BREAKER
BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs
not included.
1. Turn arms so they are equally spaced apart from each other.
2. A. Slip small notched cover and xture loop through xture
wires.
B. Install the small notched cover on top of xture, making
certain arms are locked onto It’s notches, by fastening with
xture loop.
3. Install ring onto xture by fastening with thumb screws from
behind of arms.
4. Follow enclosed supplement installation instructions for
electrical and xture installation onto house outlet box. If you do
not have an outlet box at desired location to attach the xture
than hire a qualied electrician to create one.
IMPORTANT: WHEN FOLLOWING SUPPLEMENT INSTRUCTIONS
STEP #6, MAKE CERTAIN TO SLIDE CRYSTAL BOBECHE (IN
BETWEEN COLLAR RING AND CANOPY) DOWN THE CHAIN. See
above illustration.
5. A. Install a hex nut onto one end of threaded pipe leaving about
3/8” (10mm) of thread exposed. Then install same end of pipe
by screwing onto bottom of xture. Tighten hex nut.
B. Slip large notched cover through the installed threaded pipe
and secure by fastening with nial. Make certain arms are
locked onto it’s notches before tightening nial.
6. A. Install crystal bobeche by slipping through sockets.
B. Install candle tube by slipping through sockets.
C. Install candle follower onto top of candle follower (for MBZ
nish only).
D. Install type-B, candelabra base, of 60 Watt maximum bulbs
(not included).
7. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystal or pin, extras are included in
hardware bag. Replace by gently bending open pin, remove
broken crystal or pin, hook new one, then close back pin. Avoid
bending pin into sharp angle.
Assembly Instructions For
F2475/6
Bulb
(not included)
(E) 8/13
Candle
Tube
Arm
Fixture Loop
Ring
Threaded Pipe
Large Notched Cover
Finial
Small
Notched Cover
Socket
Bobeche
Candle Follower
(Included with
MBZ nish only)
7
8
9
10
3
2
FACTORY
INSTALLED
X6
X6
X6X18X7 X6
Require
d
1
Extra
4
5
6
14
2
2
1
3
2
54 6
13 bead14 bead 11 bead
X6
X1
X6
1
1 X3
1
1
8 9
7
10
12 bead 16 bead
Extra PIN
Qty.
24
12
12
Small Bead
Hook
Large
S Hook
Small
S Hook
PIN
DESCRIPTION
PIN PART