User Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulbs not included.
1. Attach Chains:
A. Open adjustable chain links byturning small
round tube at one side.
B. Hook chain onto open adjustablechain link.
Then attach adjustablechain link onto loop located
at fixtureplate.Close adjustable chain link by
turning back small round tube.
C. Repeat other side.
D. At this point determine the desiredlength of
chains to hang. Remove anyunwanted chain links.
Additional chains can bepurchased through your
local MurrayFeiss retailer.
E. Hook another open adjustablechain link at
bottom of each chain. Then attach adjustable chain
linksonto loop located at top of fixture arm curls.
Close adjustable chainlinks by turning back small
round tube.
2. Take ground wire (without plasticinsulation) and
weave through abovechain links. Then thread
through hole infixture plate loop. Repeat with
fixturewires (with plastic insulation).
3. Follow enclosed supplement installation instructions
for electrical and fixture installation onto house
outlet box. If you do not have an outlet box at
desired location to attach the fixture then hire a
qualified electrician to create one.
4. A. Slip candle follower on top of candle tubes.
B. Install light bulb (not included). See relamping
label at socket area for type and maximum allowed
wattage.
C. Install the shade onto the bulb.
5. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystal or pin, extras are
included in hardware bag. Replace by gently
bending open pin, remove broken crystal or pin,
hook new one, then close back pin. Avoid bending
pin into sharp angle.
Assembly Instructions For
F2726/6
(E) 12/11
Ø4
Ø8
Ø16
Ø28
EXTRA
× 2
× 2 ×5 ×1 ×1 ×1 ×1 ×1
4A
4B
4C
5
5
5
5
3
1
2
Ø4
Ø8
Ø16
Ø28
EXTRA
×2
×2 ×5 ×1 ×1 ×1 ×1 ×1
×2
×6
×4
A
B
C
×1
D
A
B
C
D
C
B
B
A