User Manual

ManualsBrandsFeiss ManualsLightingF2795-3

Installation Instructions for

Alston 3 Light Chandelier

1.0

F2795-3

CAUTION - RISK OF FIRE

This product requires installation by a qualified electrician.

Before installing be sure to read all instructions and

TURNTHE POWERTOTHE ELECTRICAL BOX OFF.

Chandelier

F2795_

GP I :ENERAL RODUCT NFORMATION

This product is suitable for dry locations.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

Mount and secure all arms to the top of the fixture by tightening caps.

Mount and secure the frame to the arms by tightening the cap screws and nuts.

Install the lamp by screwing it into lamp into the socket. Refer to the label on the lamp socket for Max Wattage

information.

Depending on desired mounting (chain or semi-flush), follow enclosed supplement installation instructions for electrical

and fixture installation onto house outlet box.

LAMP

FRAME

FIXTURE

CAP SCREW

ARM

CAP

NUT

SEMI-FLUSH MOUNT INSTALLATION

Summary of content (4 pages)

PAGE 1
Installation Instructions for F2795-3 Alston 3 Light Chandelier F2795_ 1.0 Chandelier GENERAL PRODUCT INFORMATION: This product is suitable for dry locations. This product may be dimmed with a standard incandescent dimmer. CAUTION - RISK OF FIRE This instruction shows a typical installation. This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
ATTENTION – RISQUE D’INCENDIE Ce produit nécessite une installation par un électricien qualifié.Avant d'installer assurez-vous de lire toutes les instructions et TOURNER LE POUVOIR DE LA BOITE ELECTRIQUE OFF 1A CASQUETTE LUMINAIRE 2 BRAS AMPOULE INSTALLATION MONTAGE SEMI-FLUSH 4 3 ÉCROU CASQUETTE VIS CADRE 3 1 Monter et fixer toutes les armes à la partie supérieure de l'appareil en serrant bouchons. 2 Monter et fixer le cadre pour les bras en serrant les vis et les écrous.
PAGE 3
PRECAUCION – RIESGO DE INCENDIO Este producto requiere la instalación por un electricista calificado.Antes de instalar, asegúrese de leer todas las instrucciones y APAGUE EL PODER DE LA CAJA ELÉCTRICA NO. 1A TAPÓN FIXTURE 2 BRAZO BOMBILLA SEMI-FLUSH MOUNT INSTALACIÓN 4 3 TUERCA TORNILLO MARCO 3 1 Montar y asegurar todas las armas a la parte superior del aparato apretando las tapas. 2 Montar y fijar el marco a los brazos apretando los tornillos y las tuercas.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2012 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.