Installation Guide

ManualsBrandsFeiss ManualsChandeliersLismore 5-Light Polished Nickel Chandelier

Installation Instructions for

Lismore 3 and 5 Light Chandelier

1.0

F2921-3-F2922-5

Chandelier

F2921/3, F2922/5_

GP I :ENERAL RODUCT NFORMATION

This product is listed by one of the following

“ ationally ecognized esting aboratory”NR TL

This product is suitable for dry locations only.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

Install the candle tube by slipping it through the socket.

Install the shade by placing it over the candle tube.

Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information. Repeat steps 1-3 for

remaining sockets.

Using the help of another person, connect the fixture to the hub by hooking each fixture arm into the corresponding hook.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

FIXTURE

LAMP

SOCKET

SHADE

HUB

CANDLE TUBE

FIXTURE ARM

Summary of content (4 pages)

PAGE 1
Installation Instructions for F2921-3-F2922-5 Lismore 3 and 5 Light Chandelier F2921/3, F2922/5_ 1.0 Chandelier GENERAL PRODUCT INFORMATION: This product is listed by one of the following “Nationally Recognized Testing Laboratory” CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for dry locations only.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c. 1A 5 AMPOULE 3 MOYEU ABAT-JOUR TUBE BOUGIE 2 4 4 1 DOUILLE BRAS DE LUMINAIRE 4 4 LUMINAIRE 1 Installer le tube bougie en glissant à travers le socket. 2 Installer l'abat-jour en le plaçant sur le tube bougie.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A 5 BOMBILLA 3 EJE PANTALLA 2 TUBO DE LA VELA 4 4 1 ENCHUFE BRAZO DE LA LÁMPARA 4 4 LÁMPARA 1 Instale el tubo de vela lo deslizándose a través del enchufe. 2 Instale la pantalla colocándola sobre el tubo de vela.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2014 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.