Installation Guide

ManualsBrandsFeiss ManualsChandeliersSoros 20.25 in. W 4-Light Ebonized Silver Leaf Chandelier with Crystal Shade

Installation Instructions for

Soros 4 Light Chandelier

1.1

F2946-4

Chandelier

F2946/4

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant

junction boxes.

This product is safety listed for dry locations only.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the candle tubes by slipping them through the sockets.

Install the candle followers by placing them on top of the candle tubes.

Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.

Determine the height of the fixture with the provided stems and washers, then assemble them by screwing them together.

Place the stem cup on top of the stem assembly and secure it in place by tightening the fixture loop.

Feed the fixture wires through the stems, place the decorative cup onto the top of fixture, and secure it by screwing the

stem assembly onto the fixture.

Install the decorative strands by hooking them to the top, middle, and bottom of the fixture as shown on drawing.

Open the quick link and secure it onto the canopy and fixture loop by closing it, then feed the fixture wires through the

quick link and canopy.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

Summary of content (4 pages)

PAGE 1
Installation Instructions for F2946-4 Soros 4 Light Chandelier F2946/4 1.1 Chandelier GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a standard incandescent dimmer. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c. 1A 1 Installez le tubes de bougie en les glissant à travers le douille. 2 Installer les adeptes de la bougie en les plaçant sur le dessus les tubes de la bougie. 3 Vissez les ampoules dans les douilles.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A 1 Instale los tubos de vela deslizándolos a través de los enchufe. 2 Instale los seguidores de vela colocándolas encima de los tubos de vela. 3 Atornille las bombillas en los enchufes.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.969.3347 www.Feiss.com © 2015 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.