Installation Guide

1
Installation Instructions for
Botanic 4 Light Drum Pendant
Reach inside the shade and screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Place the diffuser onto the threaded pipe and secure it in place by screwing the hex nut onto the threaded pipe.
Screw the finial onto the threaded pipe.
Determine the height of the fixture with the provided stems and assemble them by screwing them together.
Secure the mounting plate to the junction box.
Feed the fixture wires through the stem assembly and screw the stem assembly to the socket assembly.
Feed the fixture wires through the canopy and screw the canopy onto the stem assembly.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Neatly place the wires into the electrical box and/or canopy, then place the canopy onto the mounting plate and secure it in place by
screwing in the fixture screws.
1
2
1A
3
4
5
6
7
8
9
Pendant
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for dry locations only.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
1.1
F3033-4
F3033/4
10
FIXTURE SCREW
MOUNTING PLATE
CANOPY
STEM
11
11
SOCKET ASSEMBLY
LAMP
4
4
4
6
7
2
1
HEX NUT
SHADE
THREADED PIPE
5
DIFFUSER
FINIAL
11
3