Owner's manual

Installation Instructions for

GP I :ENERAL RODUCT NFORMATION

This product is listed by one of the following

“ ationally ecognized esting aboratory”NR TL

This product is suitable for damp locations.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.

Screw the threaded pipe to the coupler, then place the shade over the threaded pipe and secure it by tightening the

knurled nut.

Place the decorative frame over the threaded pipe and secure it in place by tightening the finial.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

THREADED PIPE

Allier 2 Light Flush Mount

1.0

F 409M

Ceiling

F 409_M

LAMP

FINIAL

SHADE

FIXTURE BASE

DECORATIVE FRAME

KNURLED NUT

COUPLEUR

PAGE 1
Installation Instructions for FM409 Allier 2 Light Flush Mount FM409_ Ceiling GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is listed by one of the following “Nationally Recognized Testing Laboratory” This product is suitable for damp locations. Use minimum 90°c supply conductors.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2014 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.