Instructions / Assembly

ManualsBrandsFeiss ManualsCeiling Light Parts4 in. 3-Light Polished Nickel Multi-Port Pendant Canopy with Swag Hooks

Installation Instructions for

Connect the fixture to a suitable ground in accordance with local electrical codes.

Feed the power line wires through the three large holes on the mounting plate and secure the mounting plate to the

junction box.

Loosen the set screw on the strain relief using an Allen key.(Do Not Remove)

Feed the fixture cord through the strain relief and canopy.

Determine the fixture height (from the bottom of the fixture shade to top of the canopy) by moving the canopy and strain

relief up or down. When desired height is achieved, tighten the set screw on the strain relief using an Allen key.

Leave 6" of the cord behind the canopy for power connections and cut the excess cord. From the end of the cord, strip the

insulation 4" using a sharp knife. Strip the end of the wires. Repeat steps 1-6 forMake sure not to nick the inner wires.

remaining fixtures.

Connect the white fixture wires (square and/or rigid) to the neutral power line wire with a wire nut.

Connect the black fixture wires (round and/or smooth) to the hot power line wire with a wire nut.

Place all wires properly inside the canopy, place the canopy onto the threaded nipple, and secure it in place by screwing

the cap nut onto the threaded nipple.

For swag hook installation, see section 2A on page 4.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is safety listed for damp locations.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

3 Port Canopy with Swag Hook

1.0

MPC03

Canopy

JUNCTION

BOX

MOUNTING

PLATE

SET

SCREW

ALLEN

KEY

STRAIN

RELIEF

CORD

2 2

THREADED

NIPPLE

SET