Owner manual

Carefully unpack and identify all parts before assembly.

1. Lay glass mirror, with u-channels facing up, on a

non-abrasive and elevated surface.

2. Lay frame on top of glass mirror by aligning frame holding

rods into notches in u-channels. Make certain glass mirror

is centered within frame.

3. Lock holding rods into u-channel by attaching cover and

then fastening with machine screws (from inner-side of

u-channel) and lock washer and hex nut (from outer-side

of u-channel). See assembly detail graphic.

4. Hang all crystal glass parts as shown on drawing.

5. WALL MOUNTING: Requires two 30lbs. or over capacity

picture frame hangers or hooks (not included). Screws are

not recommended.

A. Decide desired wall location to hang mirror.

B. Install 2 picture frame hangers or hooks (not included)

on wall with approximately 14" distance to each other at

location corresponding with upper holding rod.

Assembly Instructions For

MR1106

Crystal Glass

(E) 5/10

Frame

Holding Rod

U-Channel

Glass Mirror

Extra PIN

Qty.

Required

Extra

Head Pin

Small S- Hook

DESCRIPTION

PIN PART

U-channel

Lock Washer & Hex Nut

Machine Screws

Holding Rod

Assembly

Detail:

Cover