Installation Guide

1
Installation Instructions for
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
Install the bottom and corner glass panels to the frame by carefully sliding them into the frame and securing them
using the brackets and bracket screws as shown.
Install the side glass panels by carefully sliding them into the frame and securing them using the clips as shown.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Secure the mounting plate to the junction box with two mounting plate screws.
Screw the threaded pipe to the bottom of the fixture base.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Place the fixture base onto the mounting plate studs and secure it in place by screwing the cap nuts on the mounting
plate studs.
Place the shade and washer onto the threaded pipe and secure them in place by screwing on the decorative cup.
Swing the frame closed and secure it in place by screwing the frame screw into the fixture base.
1
2
1A
3
4
1
1
6
7
8
5
Shepherd 2 Light Flush Mount
1.1
OL10613
Outdoor
O 10613L
CAUTION - RISK OF FIRE
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
CLIP
7
MOUNTING
PLATE STUD
MOUNTING
PLATE
8
FIXTURE BASE
MOUNTING
PLATE SCREW
LAMP
SHADE
THREADED PIPE
CAP NUT
WASHER
DECORATIVE CUP
SIDE GLASS
PANEL
BRACKETBRACKET
SCREW
CORNER
GLASS PANEL
BOTTOM
GLASS PANEL
FRAME SCREW
9
10
11
1
1
1
1
2
2
5
3
10
9
9
11