Installation Guide

Installation Instructions for

Londontowne Outdoor Hanging Lantern

(LED)

1.1

OL11309_OL11311-LED

Outdoor

OL11309, OL11311-LED

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant

junction boxes.

This product is safety listed for damp locations.

This product may be dimmed with a low voltage electronic dimmer.

This instruction shows a typical installation.

Install all glass panels by carefully sliding them into the housing and securing them using the clips.

Secure the frame to the housing using the frame screws.

Place the cover and washer onto the nipple and secure them in place by screwing the knurled nut onto the nipple, then

screw the fixture loop onto the nipple.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house junction box.

COVER

FIXTURE LOOP

FRAME

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GLASS PANEL

HOUSING

CLIP

HOUSING

WASHER

KNURLED NUT

FRAME SCREW

NIPPLE

PAGE 1
Installation Instructions for OL11309_OL11311-LED OL11309, OL11311-LED Londontowne Outdoor Hanging Lantern (LED) 1.1 Outdoor GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is safety listed for damp locations.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.969.3347 www.Feiss.com © 2015 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.