Installation Guide
IMPORTANT
TURN OFF POWER AT MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
beginning assembly. Bulb not included.
1. Install light bulb (not included). See relamping label at socket
area for type and maximum allowed wattage.
2. Install a hex nut onto one end of threaded pipe leaving about
1/2" (13mm) thread exposed. Screw same end of threaded pipe
into coupler. Tighten hex nut.
3. Slide middle cover and top cover thru center pipe till checks
onto main frame. Lock them into position with rubber washer
and finial.
4. Electrical installation onto post: If you are replacing and
existing fixture, disconnect and remove the old fixture.
A) Slip post cup over post. Mark position of holes in post
cup on post.
B) Remove post cup and expose the supply wiring from above post.
Drill 1/8" (3mm) diameter pilot holes in post at places
where marked.
C) Make wire connections. (wire connectors not provided). Refer
to chart below for correct connections. Wire supply wires to
fixture wires accordingly.
(E) 9/05
MUR R AY FEI SS
© M URR AY FEI SS I M POR T LLC .
ASSEMB LY I NST R UCT I ONS FOR OL4007
D) Connect ground wire from supply source to fixture ground wire
with connector. Never connect ground wire to black or white
power supply wires. Carefully place wires inside post.
E) Slip post cup onto post. Align holes in post cup with holes in post.
Attach post cup to post with sheet metal screws.
Tracer Wire
*Note: When parallel wire (SPT 1 & SPT2)
is used. One wire is square shaped or
ridged and the other wire will be round
in shape or smooth. (See Illustration)
Connect Black Fixture Wire to:
Black Supply Wire or
*Parallel cord
(round & smooth)
Clear, Brown, Gold or Black
without tracer
Insulated wire
(other than green)
with copper conductor
Connect White Fixture Wire to:
White Supply Wire or
*Parallel cord
(square & ridged)
Clear, Brown, Gold or Black
with tracer
Insulated wire
(other than green)
with silver conductor
Fixture Wire
Supply Wire
Finial
Rubber Washer
Top Cover
Bulb
(Not Included)
Post (Not supplied)
Fixture Ground Wire
Supply Ground Wire
Sheet Metal Screw
Socket
Post Cup
Threaded Pipe
Hex Nut
Coupler
Middle Cover