User Manual

(E) 4/07
ASSEMBLY INSTRUCTIONS FOR OL5707, OL5708
Bulb
(not
included)
Candle
Tube
Top Cover
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Middle Cover
Break
Center Pipe
Door
Door
Latch
Socket
Post Cup
Post
(not supplied)
Sheet Metal Screw
Fixture Wire
Fixture Ground Wire
Supply Wire
Supply
Ground Wire
Finial
Carefully unpack and identify all parts before
assembly. Bulb is not included.
1. Screw short threaded end of center pipe into top coupler.
2. Slip middle cover, break and top cover through the
installed center pipe. Lock all together by fastening with
finial.

3. Lift up door latch and open door.
4. Place candle tubes over candleabra sockets and screw
bulbs (not included) into sockets to secure. See relamping
label on candle tube for type and maximum alowed
wattage.
5. Close door shut and lock by pushing door latch down so it
locks into small cylinder below.
6. Electrical installation onto post: If you arereplacing an
existing fixture, disconnect andremove the old fixture.
  A) Slip post cup over post. Mark position ofholes in post
cup on post.
  B) Remove post cup and expose the supplywiring from
above post. Drill 1/8" (3mm)diameter pilot holes in post at
places wheremarked.
  C) Make wire connections. (wire connectors notprovided).
Refer to chart below for correctconnections. Wire supply
wires to fixture wiresaccordingly.
  D) Connect ground wire from supply source tofixture
ground wire with connector. Neverconnect ground wire to
black or white powersupply wires. Carefully place wires
inside post.
  E) Slip post cup onto post. Align holes in postcup with
holes in post. Attach post cup to postwith sheet metal
screws
Tracer Wire
*Note: When parallel wire (SPT 1 & SPT2)
is used. One wire is square shaped or
ridged and the other wire will be round
in shape or smooth. (See Illustration)
Connect Black Fixture Wire to:
Black Supply Wire or
*Parallel cord
(round & smooth)
Clear, Brown, Gold or Black
without tracer
Insulated wire
(other than green)
with copper conductor
Connect White Fixture Wire to:
White Supply Wire or
*Parallel cord
(square & ridged)
Clear, Brown, Gold or Black
with tracer
Insulated wire
(other than green)
with silver conductor