Installation Guide

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs not included.
1. A. Gently place glass shade inside of main frame.
B. Thread fixture wires through shade and main frame bottom holes.
C. Lock them into position by fastening with lock washer and coupler.
2. A. Install a hex nut onto one end of threaded pipe leaving about 3/8"
(10 mm) thread exposed. Screw same end of threaded pipe into coupler.
Tighten hex nut.
B. Then slide break and post cup through the installed pipe.
C. Slip rubber washer and then metal washer.
D. Lock them into position by fastening with lock washer and hex nut.
3. Screw short threaded end of center pipe into top coupler.
4. Slip candle cover tube onto sockets.
5. Install light bulb (not included). See relamping label at socket area for type
and maximum allowed wattage.
6. Slide middle cover and top cover thru center pipe till checks onto main
frame. Lock them into position with rubber washer and finial.
7. Electrical installation onto post: If you are replacing and existing fixture,
disconnect and remove the old fixture.
A) Slip post cup over post. Mark position of holes in post cup on post.
B) Remove post cup and expose the supply wiring from above post. Drill
1/8" (3mm) diameter pilot holes in post at places where marked.
C) Make wire connections. (wire connectors not provided). Refer to chart
below for correct connections. Wire supply wires to fixture wires
accordingly.
D) Connect ground wire from supply source to fixture ground wire with
connector. Never connect ground wire to black or white power supply
wires. Carefully place wires inside post.
E) Slip post cup onto post. Align holes in post cup with holes in post.
Attach post cup to post with sheet metal screws.
Assembly Instructions For
OL6007, OL6008
(E) 11/07
Coupler
Main Frame
Shade
Center Pipe
Top Cover
Middle Cover
Socket
Bulb (not included)
Candle
Tube
1
2
7
3
4
5
6
Finial
Threaded Pipe
Break
Metal Washer
Rubber Washer
Rubber
Washer
Connect Black Fixture Wire to:
Black Supply Wire or
*Parallel cord
(round & smooth)
Clear, Brown, Gold or Black
without tracer
Insulated wire
(other than green)
with copper conductor
Connect White Fixture Wire to:
White Supply Wire or
*Parallel cord
(square & ridged)
Clear, Brown, Gold or Black
with tracer
Insulated wire
(other than green)
with silver conductor
Tracer Wire
*Note: When parallel wire (SPT 1 & SPT2)
is used. One wire is square shaped or
ridged and the other wire will be round
in shape or smooth. (See Illustration)
Supply
Ground Wire
Fixture
Ground Wire
Post Cup
Lock Washer
Hex Nut
Post
(not supplied)
Sheet Metal Screw
Fixture Wire
Supply Wire
Lock Washer

Summary of content (1 pages)