User guide

ManualsBrandsFeiss ManualsLightingP1285

Installation Instructions for

Holloway 1 Light Pendant

1.0

P1285

Pendant

P1285_

Place the shade housing over the socket assembly and screw the socket assembly to the stem assembly.

Place the shade into the socket assembly and secure it by tightening the collar nut.

Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

LAMP

GP I :ENERAL RODUCT NFORMATION

This product is listed by one of the following

“ ationally ecognized esting aboratory”NR TL

This product is suitable for dry locations only.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

COLLAR NUT

SHADE

SOCKET ASSEMBLY

SHADE HOUSING

STEM ASSEMBLY

Summary of content (4 pages)

PAGE 1
Installation Instructions for P1285 Holloway 1 Light Pendant P1285_ Pendant GENERAL PRODUCT INFORMATION: This product is listed by one of the following “Nationally Recognized Testing Laboratory” CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for dry locations only. Use minimum 90°c supply conductors.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c. 1A 4 COUVERCLE D’ABAT-JOUR 1 ASSEMBLÉE DE LE DOUILLE ASSEMBLÉE DE TIGE 1 ABAT-JOUR 2 ECROU À COLLIER AMPOULE 3 1 Placez le couvercle de l'abat-jour sur la douille et vissez la douille à l'assemblée de la tige.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A 4 CUBIERTA DE LA PANTALLA 1 ASAMBLEA DE ENCHUFE ASAMBLEA DE TALLO 1 PANTALLA 2 TUERCA DE COLLAR BOMBILLA 3 1 Coloque la cubierta de la pantalla sobre la asamblea de enchufe y atornille la asamblea de enchufe a la asamblea de tallo.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2014 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.