Manual

ManualsBrandsFeiss ManualsLightingP1296

Installation Instructions for

Parkman 1 Light Pendant

1.0

P1296

Pendant

P1296_

GP I :ENERAL RODUCT NFORMATION

This product is listed by one of the following

“ ationally ecognized esting aboratory”NR TL

This product is suitable for dry locations only.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.

Install the shade to the socket assembly and secure it in place by using the thumb screws.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

LAMP

SOCKET ASSEMBLY

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

SHADE

THUMB SCREW

Summary of content (4 pages)

PAGE 1
Installation Instructions for P1296 Parkman 1 Light Pendant P1296_ Pendant GENERAL PRODUCT INFORMATION: This product is listed by one of the following “Nationally Recognized Testing Laboratory” CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for dry locations only.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c. 1A 3 ASSEMBLÉE DE DOUILLE VIS DE POUCE 2 1 AMPOULE ABAT-JOUR 2 1 Vissez l'ampoule dans la douille. Lire l'étiquette sur la douille de lampe pour informations Max Wattage.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A 3 ASAMBLEA DE ENCHUFE TORNILLO DE PULGAR 2 1 BOMBILLA PANTALLA 2 1 Enrosque la bombilla en el enchufe. Consulte la etiqueta en el zócalo de la lámpara para obtener información de Max Wattage.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2014 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.