Instruction Manual

ManualsBrandsFeiss ManualsLightingP1303

Installation Instructions for

Lismore 1 Light Pendant

1.0

P1303

Pendant

P1303_

Place the shade over the socket, then secure it in place by tightening the collar nut.

Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

LAMP

GP I :ENERAL RODUCT NFORMATION

This product is listed by one of the following

“ ationally ecognized esting aboratory”NR TL

This product is suitable for dry locations only.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

COLLAR NUT

SHADE

SOCKET ASSEMBLY

Summary of content (4 pages)

PAGE 1
Installation Instructions for P1303 Lismore 1 Light Pendant P1303_ Pendant GENERAL PRODUCT INFORMATION: This product is listed by one of the following “Nationally Recognized Testing Laboratory” CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for dry locations only. Use minimum 90°c supply conductors.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c. 1A 3 ASSEMBLÉE DE LE DOUILLE ABAT-JOUR 1 ECROU À COLLIER 2 AMPOULE 1 Placez l'abat-jour dans le douille et fixez en place pour serrant l'écrou à collier. 2 Vissez le ampoule dans le douille.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A 3 ASAMBLEA DE ENCHUFE PANTALLA 1 TUERCA DE COLLAR 2 BOMBILLA 1 Coloque la pantalla y, luego asegúrelo apretando la tuerca de collar. 2 Enrosque la bombilla en el enchufe.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2014 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.