Installation Guide

1
Installation Instructions for
Brynne Pendant
1.0
P1442-P1443-LED
Pendant
P1442, P1443-LED
Determine the wanted height of the fixture by feeding the cord through the canopy and moving the cord up or down.
Place the cord in between the two cord clips and secure it in place using the clip screws.
Trim the cord leaving enough for electrical connections. From the end of the cord, strip the insulation 4” and then strip the end of
the wires. Note: Make sure not to nick the inner wires.
Install the brackets to the LED assembly using the thumb screws.
Align the holes on the shade with the holes on the brackets and secure them together using the thumb screws and nuts.
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place with the set
screws using an Allen key.
1
2
1A
LED ASSEMBLY
BRACKET
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
CORD
3
4
5
9
10
6
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
For a complete list of dimmers, visit out website at www.Feiss.com
5
4
5
7
8
9
SHADE
THUMB SCREW
THUMB NUT
CANOPY
SET SCREW
ALLEN KEY
MOUNTING PLATE
JUNCTION BOX
8
CORD
CANOPY
CORD CLIP
CLIP SCREW
2
3
10