Installation Sheet

1
Installation Instructions for
Loras Pendant
1.0
P1449
Pendant
P1449
Determine the wanted height of the fixture by feeding the cord through the canopy and moving the cord up or down.
Place the cord in between the two cord clips and secure it in place using the clip screws.
Trim the cord leaving enough for electrical connections. From the end of the cord, strip the insulation 4” and then strip the end of
the wires. Note: Make sure not to nick the inner wires.
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place with the set
screws using an Allen key.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage information.
1
2
1A
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
CORD
3
4
5
7
8
6
9
7
8
LAMP
CANOPY
SET SCREW
ALLEN KEY
MOUNTING PLATE
JUNCTION BOX
6
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
CORD
CANOPY
CORD CLIP
CLIP SCREW
9
2
3