Owner manual

(E) 10/04
ASSEMB LY I NST RUCT I ONS FOR SF194
IMPORTANT
TURN OFF POWER AT MAIN FUSE OR
CIRCUIT BREAKER BOX BEFORE
STARTING INSTALLATION
 Carefully unpack and identify all parts
before assembly. Bulbs are not included.
1. Screw center pipe onto fixture plate while 
 removing any slack in wires in between parts.
2.  Install arms.
 A. Install upper section of arms onto fixture 
 plate by fastening with small lock washer and 
 small hex nut.
 B. Install lower section of arms onto pan by 
 fastening with machine screws.
3. Install a hex nut onto one end of long threaded 
 pipe leaving about 1/2 in. (13mm) thread 
 exposed. Screw same end of threaded pipe 
 into coupler. Tighten hex nut.
4. Slip glass shade up till it checks into bottom of
 pan. Then lock into position by fastening with
 flat washer and hex nut. Do not over tighten.
5.  Slip lower font through same threaded pipe
 and lock into place by fastening finial.
6. Install light bulb (not included). See relamping
 label located at socket area for type and
 maximum allowed wattage.
7. Follow enclosed “Multiple Standard
 Installation Instructions” for electrical and
 fixture installation onto ceiling outlet box.
MUR R AY FEI SS
©M UR R AY FEI SS I MPORT L LC .
Arm
Small Hex Nut
Small Lock Washer
Machine Screw
Fixture Wires &
Ground Wire
Center Pipe
Bulb
(not included)
Pan
Hex Nut
Long Threaded
Pipe
Glass Shade
Flat Washer
Hex Nut
Lower Font
Finial
Fixture Plate