Owner's manual

(E) 4/06

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE

OR CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before

assembly. Bulb not included.

1. Install center column by screwing securely into 

 fixture plate.

2. Install a hex nut onto one end of long threaded stud 

 leaving about 3/8" (10 mm) of thread exposed.  

 Screw same end of threaded stud into bottom of  

 socket assembly. Tighten hex nut.

3. Follow enclosed supplement installation   

 instructions for electrical and fixture installation

 onto house outlet box. If you do not have an

 outlet box at desired location to attach the fixture  

 than hire a qualified electrician to create one.

4.  Install bulbs (not included). See relamping label  

 located at socket area for type and maximum  

 allowed wattage.

5. A . Hang all suspension arms onto hooks located at 

 fixture plate.

B. Hang crown by hooking onto the suspension arms.

C. Slip glass shade through the installed threaded  

 stud until it checks inside of crown.

D. Hold glass shade in position by fastening with a 

 flat washer and hex nut. Do not over tighten since it 

 will raise the crown further up.

E. Slip break through same threaded stud and lock in 

 position by fastening with finial.

Fixture Plate

Suspension

Arm

Glass Shade

ASSEMBLY INSTRUCTIONS FOR SF220

Break

Crown

Threaded Stud

Finial

Bulb

(not included)

Flat Washer

Hex Nut

Center

Column