Installation Guide

1
Installation Instructions for
Lucia 6 Light Semi Flush Mount
1.1
SF329
Ceiling
SF329
1A
CAP NUT
CAP SCREW
DIFFUSER
CANOPY
WASHER
JUNCTION BOX
11
6
SWIVEL
SWIVEL SCREW
11
9
8
22
44
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent
dimmer. version may be dimmed with a dimmer. ConsultLED LED
lamp manufacturer for additional information.
MOUNTING
PLATE
MOUNTING PLATE STUD
ANCHOR
ANCHOR SCREW
Temporarily install the mounting plate to the junction box and mark the anchor hole locations, then remove the mounting plate.
Drill appropriate sized holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Install the anchor screws into the anchors.
Feed the fixture wires through the swivel and canopy, then screw the canopy onto the fixture and tighten the swivel screw.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate studs, and secure it in place by
screwing the cap nuts onto the studs.
Align the holes on the diffuser with the holes on the fixture, then secure it in place using the washers and cap screws.
1
2
3
4
5
6
7
8
9
10
11
1010
5