Installation Guide

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulbs not included.
1. Install mounting plate (see fig. 1):
A. Take supply wires from outlet box and carefully pass
them through center hole of mounting plate. Note: The
flat surface of mounting plate must face the outlet box
and the angled rim side facing toward you.
B. Install mounting plate onto the outlet box using two
screws supplied with outlet box.
C. Spread electrical wires so that black wires are on
one side of the outlet box and the white wires are on
the other side.
2. Connect electrical wires (see fig. 1):
A. Connect white fixture wire(s) to white supply wire
from outlet box with wire connector. Connect black
fixture wire(s) to black supply wire from outlet box
with wire connector.
NOTE: Black outlet box wire may be red, round and
smooth and/or have copper conductor. White outlet
box wire may be square and ridged and/or have a silver
conductor.
B. Connect fixture ground wire (without plastic
insulation) to ground wire from outlet box (usually
with green insulation) with wire connector.
Note: If there is no supply ground wire at outlet box
then attach fixture ground wire securely onto green
grounding screw located at mounting plate. See fig. 2.
IMPORTANT: Never connect ground wire to black or
white supply wires (from outlet box).
3. Install fixture plate. While carefully tucking all electrical
wires inside of fixture plate, install the fixture plate
onto the mounting plate by fastening with set screw.
Use provided hex key to tighten.
4. Install shade onto fitters by fastening with spacer tube
and counter ring.
5. Install light bulb (not included). See relamping label at
socket area for type and maximum allowed wattage.
Assembly Instructions For
(E) 5/10
5
4
FIG. 1
FIG. 2
3
2
1
VS16601, VS16602, VS16603, VS16604