Installation Guide

1
Installation Instructions for
Putnam 1, 2, and 3 Light Vanity Strip
1.0
V 2280_S
VS22801,VS22802,
VS22803
Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Install the shade over the socket and secure it with the collar nut using the shade tool.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information. If necessary, repeat
steps 6 and 7 for remaining sockets.
1
2
3
1A
LAMP
4
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
NEUTRAL WIRE
WHITE WIRE
1
1
5
6
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
MOUNTING
PLATE SCREW
SHADE
7
FIXTURE SCREW
ALLEN WRENCH
6
7
COLLAR NUT
5
SHADE TOOL