Instructions / Assembly

1
Installation Instructions for
Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screw using an Allen wrench.
Install the candle tube by slipping it over the socket.
Install the candle follower by placing it on top of the candle tube.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Repeat steps 6-8 for remaining sockets.
1
2
3
1A
4
5
6
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
7
Hartsville 1 and 2 Light Wall
1.1
WB1755_WB1756
W 1755, WB1756B
Wall
8
LAMP
JUNCTION BOX
MOUNTING
PLATE
SOCKET
MOUNTING
PLATE SCREW
FIXTURE SCREW
CANDLE TUBE
1
3
6
CANDLE FOLLOWER
ALLEN WRENCH
4
1
7
8
9