Installation Guide

1
Installation Instructions for
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations on the mounting plate and remove the mounting plate.
Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Install the candle tube by slipping it over the socket.
Install the candle follower by placing it on top of the candle tube.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Install the shade onto the small threads and secure it in place using the washers and cap nuts.
Insert the threaded pipes from the shade through the fixture base, then secure in place using the washer and hex nuts.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the set screw using an Allen wrench.
1
2
3
4
5
Katerina Wall
1.0
W 1845B
W 1845B
Wall
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
6
7
8
9
10
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
11
12
13
14
1A
JUNCTION BOX
MOUNTING
PLATE
12
13
ALLEN KEY
SET SCREW
ANCHOR
ANCHOR
SCREW
LAMP
14
8
3
5
CANDLE
FOLLOWER
AND TUBE
THREADED PIPE
SHADE
HEX NUT AND
WASHERS
FIXTURE BASE
7
6
10
SMALL THREAD
CAP NUT AND WASHER
9
9
10