Instructions / Assembly

LED UTILITY LIGHT INSTALLATION INSTRUCTIONS
MODEL 73985
FEIT ELECTRIC COMPANY | PICO RIVERA, CA | [phone] | FAX [phone] | www.feit.com
WARNING: These products may represent a possible shock or re hazard if improperly
installed or attached in any way. Products should be installed in accordance with the owners
manual, current electrical codes and/or the current National Electric Code (NEC).
CAUTION, IMPORTANT SAFETY INSTRUCTIONS - This portable light-emitting-diode
(LED) luminaire has a polarized plug (One blade is wider than the other) As a feature
to reduce the risk of electric shock. This plug will t in a polarized outlet only one
way. If the plug does not t fully in the outlet, reverse the plug. If it still does not t,
contact a qualied electrician. Never use with an extension cord unless plug can be
fully inserted. Do not alter the plug."
PARTS INCLUDED
(1) 4 foot xture with on/o switch
(2) mounting screws
(2) 6 inch hanging cables
(1) 5 foot plug-in cord
LIMITED WARRANTY
This product is warranted to be free from
defects in workmanship and materials for up
to 5 years from date of purchase. If it fails to
do so, please contact Feit Electric at
[e-mail] or call 1-866 326-BULB (2852)
for instructions on replacement. Do not
return the product to the store.
For comments please write to:
Feit Electric
Customer Service Department
4901 Gregg Road, Pico Rivera, CA 90660
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Note: This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
47.26”
4.9”
1.65”
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna. Increase
the separation between the equipment and receiver. Connect the equipment
into an outlet on a circuit dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
THIS FIXTURE IS INTENDED TO
BE ONLY INSTALLED DIRECTLY
BENEATH A CEILINGMOUNTED
RECEPTACLE.