74202/CA/V2 USE AND CARE GUIDE 5 INCH DIMMABLE WHITE ROUND FLAT PANEL CEILING LIGHT WITH SELECTABLE COLOR FEIT ELECTRIC COMPANY | PICO RIVERA, CA | 1-866-326-BULB (2852) | www.feit.
Table of Contents Table of Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Pre-Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pre-Installation TOOLS REQUIRED Phillips screwdriver HARDWARE INCLUDED NOTE: Hardware not shown to actual size. AA FF BB GG CC HH DD II EE JJ Part Description Quantity AA 5 in. fixture 1 BB Mounting bracket 1 CC 4 in. mounting clip spring 3 DD E26 adapter with male connector 1 EE Stripped wires with male connector 1 FF Ground wire 1 GG 4 in. mounting clip spring screws 3 HH Ground wire screw 1 II J-Box mounting screws 2 JJ Wire connectors 3 3 WWW.FEIT.
Junction Box Installation 1 4 Turning Off the Power □□ Turn the power OFF at the switch and fuse box or the circuit breaker. 2 Installing the mounting bracket to the junction box □□ Install the mounting bracket (BB) to the J-box by inserting the two mounting screws (II) through the slots in mounting bracket (BB). □□ Make sure the mounting bracket (BB) is installed with the label facing downwards. (Fig.
4 in. Recessed Can Installation 1 2 4 Turning Off the Power □□ Turn the power OFF at the switch and fuse box or the circuit breaker. □□ Remove the existing trim installed in the recessed housing. Installing the 4 in. clip springs to the mounting bracket □□ Install the 4in. clips springs (CC) to the mounting bracket (BB) using the three clip spring screws (GG) provided (See Fig. 3). □□ Make sure the mounting bracket (BB) is installed with the label faced downwards (See Fig. 4).
Changing the Color Settings NOTICE: The toggle switch is located on the back of the fixture. 4-way color changing: To change color temperatures using your existing light switch: 1. You can lock in one color temperature, change among multiple color temperatures, dim from 1%100%, memorize the last color temperature and reset automatically. A. Set the slide switch on the back of the fixture to SWITCH. 2.
