ECLIPSE IC USE AND CARE GUIDE SOLAR BOLLARD LIGHT Questions, problems, missing parts? Before returning to store, visit for further assistance. @ We appreciate the trust and confidence you have placed In Colt Electric through the purchase of this Solar LED Bollard Light. We strive to continually create quality products designed to enhance your home. Visa us online to see our full line of products available for your home Improvement nods. Thank you for choosing Colt Electric.
Table of Contents .. Hardware Included . Pr-Charge Bollard Light Installation . Operation without Re mots . . Operation with Remote . . . Battery Replacement .. Setup with Smart Bridge . .. . TROUBLESHOOTING oie rite ate eee e ete PRUNE RBDBWBSNNN READ BEFORE INSTALLATION AND SAVE THESE INSTRUCTIONS This advice compiles with part 15 of the FCC Rules.
TOOLS REQUIRED Phillips Rubber Mallet AA BB BB screwdriver HARDWARE INCLUDED Bollard Light 7 In. Pole Ground Stake 1 For best performance, charge the unit for two 2) days prior to use o Remove the insulating tab. In order to properly charge, the unit must ba turned OFF. Use the On/Off/Cycle button to cycle through all of the colors (Soft White, Bright White, Cool White, Daylight, Deluxe Daylight, Red, Blu, Green, Yellow, Orange, Purple, Teal, and Pink) and reach the OFF position .
Peel off sticker from solar panel and remove insulating tab 1 o Peel off the sticker from the solar panel. 0 Removal the insulating tab. oO It is recommended that you charge the unit for two (2) days before use to adequately charge the battery, following the Pr-Charge instructions. N Installing the stake 0 Push the ground stake (CC) Into the ground. Using rubber mallet, Insert ground stake (CC) deep enough Into the ground to ensure fully assembled bollard light (AA) Is stable and does not tip over.
Operating with a One Sync remote allows for expanded control. Modify settings of individual One Sync units or multiple units in groups. The One Sync Remote has a 100 control range and will command all paired units within 100 of the remits. All One Sync units are equipped with a signal repeater that will repeat any remote commands to all other units within 100ft.
1 Downloading and installing the Fe it Electric app 0 Search for the Fe it Electric app in the App Store or Google Play Store. oO Download and Install the Fe it Electric app on your smart unit. oO Connect to a 2.4GHz WI-Fi network that covers your installation location. O Fallow the instructions in the Fe it Electric app & Smart Bridge manual to pair your One Sync lights. PROBLEM [ao] 5 The battery is not making contact.
CLE FAT | Electric Questions, problems, missing parts? Before returning to store, visit for further assistance. @ FAT ELECTRIC COMPANY | PIC RIVERA, CA | www.feit.