Installation Guide

Vｅｒｓｉｏｎ 2 ．０

Diagram of recessed xture

6” Recessed housing X=155mm (6¼“)

5” Recessed housing X=135mm (5

⅜”)

(

1. Installation into Existing Recessed Incandescent Fixture:

For use with 6” OR 5" recessed housings (housing sold separately)

LED recessed trim will retrofit into select existing 6” or 5" nominal incandescent housings.

Step 1.

Step 2.

Step 3.

Step 4.

Step 5.

Turn OFF power at switch and fusebox or circuit breaker.

Remove existing trim installed in recessed housing (if necessary).

If applicable, slide lampholder bracket to its upward maximum position. If the lampholder

bracket is less than 4.5 inches from the bottom edge of the fixture enclosure, the lampholder

bracket must be removed.

If necessary, remove the lampholder mounting bracket (see FIG. 2) and the lampholder from the

bracket (see FIG. 2), then attach the provided label to the existing luminaire.

Install adapter into socket (see FIG. 3).

Install the adapter

FIG. 1A FIG. 2

FIG. 3

FIG. 1B

Remove

lamp holder

bracket

(if necessary)

(SEE BELOW)