User Manual

© 2000 Fel-Pro Incorporated Printed in U.S.A.
Form No. I-538 (Rev. 11/00)
Fel-Pro products are the result of exhaustive
research and strict quality control. However,
no sealing product is better than the quality of
its installation.
INTAKE AND EXHAUST
MANIFOLD GSKETS
CLEAN MATING SURFACES of all foreign
material including old gaskets, RTV and oil. You
may wish to use a degreaser.
CLEAN ALL THREADS by using a wire brush
for bolts and studs, tap all bolt holes and stud
nuts. Apply a high temperature anti-seize lubri-
cant to the bolt and stud threads.
ATTACH AND ALIGN GASKET(S) TO
CYLINDER HEAD(S). If gasket is steel faced
on one side and fiber on the other, install steel
faced side toward the manifold.
REINSTALL INTAKE AND EXHAUST MANI-
FOLDS to the cylinder heads. Torque securely
to OEM specifications. Over-torquing can frac-
ture the manifolds or cause the bolts and studs
to break.
EXHAUST PIPE FLANGE
CLEAN MATING SURFACES of all foreign
material. You may use a degreaser.
CLEAN ALL THREADS by using a wire brush
for bolts and/or studs. Apply a high tempera-
ture anti-seize lubricant to the bolt and/or stud
threads.
ATTACH AND ALIGN GASKET.
REINSTALL
EXHAUST PIPE FLANGE AND/OR E.G.R.
VALVE GASKET(S) TO ENGINE. Torque se-
curely to OEM specifications. Over-torquing can
cause the bolts and studs to break.
TEST RUN ENGINE. To determine that all seals
hold during operation.
- continued -
© 2000 Fel-Pro Incorporated Printed in U.S.A.
Form No. I-538 (Rev. 11/00)
Fel-Pro products are the result of exhaustive
research and strict quality control. However,
no sealing product is better than the quality of
its installation.
INTAKE AND EXHAUST
MANIFOLD GSKETS
CLEAN MATING SURFACES of all foreign
material including old gaskets, RTV and oil. You
may wish to use a degreaser.
CLEAN ALL THREADS by using a wire brush
for bolts and studs, tap all bolt holes and stud
nuts. Apply a high temperature anti-seize lubri-
cant to the bolt and stud threads.
ATTACH AND ALIGN GASKET(S) TO
CYLINDER HEAD(S). If gasket is steel faced
on one side and fiber on the other, install steel
faced side toward the manifold.
REINSTALL INTAKE AND EXHAUST MANI-
FOLDS to the cylinder heads. Torque securely
to OEM specifications. Over-torquing can frac-
ture the manifolds or cause the bolts and studs
to break.
EXHAUST PIPE FLANGE
CLEAN MATING SURFACES of all foreign
material. You may use a degreaser.
CLEAN ALL THREADS by using a wire brush
for bolts and/or studs. Apply a high tempera-
ture anti-seize lubricant to the bolt and/or stud
threads.
ATTACH AND ALIGN GASKET.
REINSTALL
EXHAUST PIPE FLANGE AND/OR E.G.R.
VALVE GASKET(S) TO ENGINE. Torque se-
curely to OEM specifications. Over-torquing can
cause the bolts and studs to break.
TEST RUN ENGINE. To determine that all seals
hold during operation.
- continued -