Operation Manual

4
The instructions contained in this manual must be strictly
followed, it should be carefully read and kept close at hand to
use when carrying out maintenance on the indicated parts.
If the machine and charger are used carefully and normal
maintenance is carried out, they will work well for a long
time.
The functions and use of the tool you have bought shall be
only those described in this manual. Any other use of the tool
is strictly forbidden.
ILLUSTRATIONS
DESCRIPTION (See gures)
A Keyless drill chuck
B Torque adjustment ring
C Speed selector
D Forward/reverse switch
E On/off/speed adjustment switch
F Battery
G Battery release button
H Screwdriver bit
I Battery charger
J Charging light
K Net light
L Lamp
M Discharging light
OTHER PRECAUTIONS
- Always connect the charger to a mains supply pro-tected by
a thermal cut out switch, for your own safety, in accordance
with established safety regulations regarding low-voltage
electrical installations.
- When drilling in walls, ceilings or oors, take care to avoid
TECHNICAL DATA
electric cables and gas or waterpipes.
USES OF THE MACHINE
• Tightening and loosening screws for metals, screws for
wood, screw that do not require a hole to be drilled previously,
etc.
• Drilling in various types of metal.
• Drilling in various types of wood and plastic.
Any use that differs from the aforementioned is unau-
thorised.
ADJUSTMENTS AND FUNCTIONS
1. Forward/reverse switch
To select the direction of rotation:
• clockwise: push the D selector to the right.
• anti-clockwise: push the D selector to the left.
The anti-clockwise turn enables screws and nuts to be
loosened.
Warning! Only push the forward/reverse switch D when the
machine is switched off.
2. Electronic speed adjustment
The speed can be adjusted continuously, not by stages,
according to the pressure exerted on the on/off switch E, from
the machine being switched off to the highest value for both
speeds, as shown in the table.
This drill is tted with a reverse-current brake, which stops the
bit when the variable speed control is com-pletely released.
3. Mechanical speed adjustment
These machines are equipped with a two-speed mechanism.
The selector C enables the speed to be adjusted to suit each
use.
• Low speed (1) (lever backwards) for screwdriver action
Battery-driven drills DCF10/10.8R DCF10/14.4R2 DCF10/18R2
Voltage V 10,8 14,4 18
Type of battery Li-ion Li-ion Li-ion
Battery capacity Ah 1,3 1,3 1,3
No load speed
Speed 1
Speed 2
/min
0-600
-
0-350
0-1100
0-400
0-1100
Torque Speed 1/2Nm
Nm 10/- 15/11 16/12
ø drill in steel mm 10 10 10
ø drill in wood mm 16 30 30
ø Max. screw mm 5 6 6
Drill chuck capacity mm 10 10 10
Keyless chuck + + +
No. of torque settings 15 15 15
Reversible / Electronic +/+ +/+ +/+
Charging Time min 60 60 60
Weight according EPTA-
Procedure 01/2003
Kg 1,0 1,4 1,4
Noise and vibration dB(A) 85