Manual

Eliminates frustrating jams by preventing overloads and powering through misfed paper.
JAM PROOF SYSTEM OPERATION*
*100% Jam Proof when used in accordance with user manual
3
AdvancedJamPrevention-Electronically
measures paper thickness to prevent paper jams:
Remove several sheets until
indicator is below red.
Continue100%Jam
Proof Shredding
If a misfeed
occurs:
If
illuminates after paper has been
reversed, press reverse and remove paper.
Otherwise, regular shredding will resume.
1 2 3
Up to RED: Too Many
sheets have been inserted.
Up to GREEN: More sheets
can be added.
Up to YELLOW: Productivity
is optimized.
All indicators light up and
shredderpausesfor3-6seconds
Wait for flashing to stop after automatic correction
is complete. Regular shredding will resume.
15
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
BASIC PRODUCT MAINTENANCE AND TROUBLESHOOTING
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry).
Allcross-cutshreddersrequireoilforpeakperformance.Ifnotoiled,a
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
3
Turn off and unplug
shredder
LocateAuto-start
infared sensor
Using cotton swab, wipe
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
AUTO AUTO AUTO
1
C-225
C-225
2 4
C-225
2
Shred one sheet
AUTO AUTO AUTO
3
Press and hold forward
()2-3seconds
C-225
1
*Apply oil across entry
C-225
C-225
3 4
C-225
C-225
SAFESENSE
®
TECHNOLOGY OPERATION
WHEN IN SLEEP MODE
SLEEP MODE
1
3
In sleep mode
To get out of sleep mode
touch control panel
insert paperor
AUTO AUTO AUTO
2
SET-UP AND TESTING
Turn the shredder ON
( ) to activate SafeSense
®
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active and
working properly
If hand is held on SafeSense
®
area more than 2 seconds
Shredder will shut off
AUTO AUTO AUTO
1
C-225
2
PREVENTIVE MAINTENANCE AND MISCELLANEOUS TROUBLESHOOTING
• SelfCleaningCycle:Shredderperiodicallycyclesinforwardandreverselasting3-6seconds(C-225Ci).
• Emptywastebasketwhenbinfullindicatorlightsup.
• Shredderwon’trunifthedoorisopen,orbinneedstobeemptied.
• Maintenanceisanimportantpartofprotectingyourinvestment.Don’tforgetouroil(35250)andshredderbags(36054).
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.