Product Card

6
7
OPERATING INSTRUCTIONS
STEP 2
Attach the handset using the included adhesive strip or using two M3 Phillips round head screws
• Position the handset on the left or right side of the table, according to user preference.
• Mount the handset flush to the front edge of the table.
• Plug handset into controller on base.
• Plug power cable into controller on base and into an power outlet.
INITIALIZE THE SYSTEM
IMPORTANT: The initialization procedure below must be completed before operating the table.
CAUTION: Ensure proper clearance. Make sure all objects are clear of the table
• Press and hold down the paddle and M buttons simultaneously for 10-15 seconds.
• The legs will begin to move down at half speed of normal operation.
• Continue to hold the buttons.
• The legs will move down to the lowest position, then rebound 1/16" to 3/16" (2mm
to 5mm) and stop.
• Release both buttons at the same time. This completes the initialization procedure.
• If initialization is started and not finished, the table will not operate. You must finish
the initialization process.
RESET THE CONTROL UNIT TO FACTORY SETTINGS
Follow the same instructions to initialize the system.
GENERAL OPERATION
Move the table up or down by pressing down or pulling up on the lever until the work
surface reaches the desired height.
The table will continue to move up or down until you release the button or until the
maximum or minimum height is reached.
MEMORY STOP POSITIONS
There are two groups of memory settings, each with two height settings. To toggle
between the two users momentarily press the M button and display will read U1 or
U2. Up to four memory stop positions can be used to save specific heights of the work
surface. To set a specific position:
Raise or lower the table to the position you want to save.
Press and hold the M button for two seconds, the LED display will blink. This means it
has stored the location. To clear storage settings, press and hold M button for 8 seconds
until CLR displays.
CHANGING THE HEIGHT DISPLAY UNITS
This function allows you to toggle the display units from inches to centimeters.
Press and hold up and down at same time for 10 seconds.
STEP 3
Level Feet
• If table feels unbalanced adjust the (4) leveling pads located on bottom of feet
• Turn clockwise to lower and counterclockwise to raise
Height
Display
Memory Set
Button
Raise/Lower
Paddle
Raise
Lower