User Manual

This modular complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. Due to missing shielding the module
is strictly limited to integration by the Grantee himself or his dedicated OEM integrator
under control of the Grantee. However, the OEM integrator is still responsible for testing
their end-product for any additional compliance requirements required with this module
installed.
IMPORTANT NOTE:
This device is intended only for OEM integrators under the following conditions:
(1) According to FCC P art 15 Subpart C Section 15. 212, t he radio e lements o f t he
modular trans mitter must have their own shieldi ng. However, due to th ere is no
shielding for thi s WIFI/ BT module, this module is granted as a Li mited Modular
Approval.
(2) This module has been designed to ope rate with PCBA antenna having a m aximum
gain of 1.0dBi.
(3) Integration is t ypically s trictly r estricted t o Grantee hims elf or dedicat ed OEM
integrators under control of the Grantee.
The m odule will be responsible t o satisfy SAR/RF Exposure requirement s, when the
module integrated into any (portable, mobile, fixed) host device.
This module is intended for OEM integrator only and the OEM integrators and instructed
to ensure that the en d user ha s no manual in structions to remove or in stall the device.
The OEM integrator is st ill responsible for the FCC compliance requirement of t he end
product, which integrates this module.
The module has no shielding and tested stand alone. This module is tested and
approved as Limited modular approval with stand alone configuration, any OEM
incorporated this radio module into any system are require additional testing and
evaluation.
The module is only certified with the installed antenna. Any change of the antenna will
void the certification.
