User's Manual

Fender FMA BT-FTSW-USB PCBA (PN 7710068000) Page 6
Manual and Spec, revision 1.0 November 8, 2016
or his dedicated OEM integrator under control of the Grantee. However, the OEM integrator is still
responsible for testing their end-product for any additional compliance requirements required with this
module installed.
IMPORTANT NOTE:
This device is intended only for OEM integrators under the following conditions:
(1) According to FCC Part 15 Subpart C Section 15.212, the radio elements of the modular transmitter
must have their own shielding. However, due to there is no shielding for this WIFI/BT module, this
module is granted as a Limited Modular Approval.
(2) This module has been designed to operate with PCBA antenna having a maximum gain of 0dBi.
(3) Integration is typically strictly restricted to Grantee himself or dedicated OEM integrators under
control of the Grantee.
The module will be responsible to satisfy SAR/RF Exposure requirements, when the module integrated
into any (portable, mobile, fixed) host device.
This module is intended for OEM integrator only and the OEM integrators and instructed to ensure that
the end user has no manual instructions to remove or install the device. The OEM integrator is still
responsible for the FCC compliance requirement of the end product, which integrates this module.
The module has no shielding and tested stand alone. This module is tested and approved as Limited
modular approval with stand alone configuration, any OEM incorporated this radio module into any
system are require additional testing and evaluation.
The module is only certified with the installed antenna. Any change of the antenna will void the
certification.
IC Notice:
This device complies with Canada Industry licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference; and
(2) this device must accept any interference. Including interference that may cause undesired operation
of the device.
Avis d’Industrie Canada
Le présent appareil est conforme aux CNR d'industrie Canada applicables aux appareils radio exem pts
de licence L'exploitation est autorisée aux deux conditions suivantes:
1) I'appareil ne doit pas produire de brouillage; et
2) I'utillsateur de I'appareil doit accepterbrouillage radioélectrique subi meme si le brouillage est
susceptible d'encompromettre le fonctionnement. mauvais fonctionnement de I'appareil.