User Manual

ENGLISH
3
Rear Panel
H. FUSE: Provides electrical over-current protection. With power
disconnected, replace a blown fuse only with one of the type
and rating specified on the amp’s rear panel.
I. IEC POWER INLET: Using the included power cord, connect
to a grounded outlet in accordance with the INPUT POWER
voltage and frequency specified at the power inlet.
J. SPEAKER OUTPUT: Connect external speaker cabinet here (8
minimum). On Bassbreaker 007 combo model, use of this jack
automatically disconnects internal speaker.
!
To avoid damaging the amp, turn it off (G) when changing
speaker connection.
K. LINE OUTPUT: Provides a line-level signal with tone shaping
from the preamp. Power amp distortion, if any, will be included
in this signal, which can be sent to effects devices such as delay
or chorus units and to the effects loop or power amp input of
another amplifier. Signal is also suitable for external recording
interfaces and sound reinforcement equipment (note that this
offers no speaker emulation).
L. FOOTSWITCH: Connect optional single-button TREBLE
BOOST (B) footswitch here.
For questions and troubleshooting, contact a Fender
specialist at:
--- (U.S. toll free)
--- (International)
Specifications
TYPE PR 3032
POWER Requirements: 55 watts Output: 7 watts into 8Ω
INPUT IMPEDANCE 1MΩ
SPEAKER (INTERNAL) One 10” Celestion® Ten Thirty (8Ω, PN 7700223000)
EXTERNAL SPEAKER ENCLOSURE Bassbreaker BB-112 (optional, PN 226700000, contains one 12” 8Ω Celestion® speaker)
TUBES V1: 7025/12AX7A/ECC83 V2: 7025/12AX7A/ECC83 V3: 6BQ5/EL84
LINE OUT Output impedance: 100Ω
ACCESSORIES Single-button footswitch (optional, PN 7706424000) Combo cover (optional, PN 7707881000) Amp head cover (optional, PN 7707882000)
DIMENSIONS (COMBO) Width: 15.81” (40.2 cm) Height: 14.75” (37.5 cm) Depth: 8.5” (21.6 cm)
WEIGHT (COMBO) 25.5 lbs. (11.5 kg)
DIMENSIONS (HEAD) Width: 15.81” (40.2 cm) Height: 8.94” (22.7 cm) Depth: 8” (20.3 cm)
WEIGHT (HEAD) 16.6 lbs. (8 kg)
Product specifications subject to change without notice.
0 10
0 10 0 10 0 10 0 10
INPUT GAIN BASS MIDDLE TREBLE MASTER POWER
TREBLE
BOOST
FENDER MUSICAL INSTRUMENTS BASSBREAKER 007
TM
INPUT POWER
55W
120V 60Hz
F2A L
250V
FUSE
SPEAKER
OUTPUT
7 WATTS
8Ω MIN
LINE
OUTPUT
COMBO ONLY:
MUTES
INTERNAL SPEAKER
SWITCH
FOOT
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE BACK COVER.
NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
CAUTION: TO REDUCE THE RISK OF FIRE,
REPLACE FUSE WITH SAME TYPE AND RATING
TYPE: PR 3032
SERIAL NUMBER
WARNING:
MAINTAIN 6" CLEARANCE
FOR VENTILATION.
WARNING: FENDER AMPLIFIER SYSTEMS ARE CAPABLE OF PRODUCING VERY
HIGH
SOUND PRESSURE LEVELS WHICH MAY CAUSE TEMPORARY OR PERMANENT HEARING
DAMAGE. USE CARE WHEN
SETTING AND ADJUSTING VOLUME LEVELS DURING USE.
A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORP.,
CORONA, CA U.S.A.
MADE IN MEXICO
BASSBREAKER 007
TM
フェンダー·
ミュージック(株)
CAUTION: CHASSIS SURFACE HOT
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
AVERTISSEMENT: RISQUE DE CHOC ELECTRIQUE ! NE PAS OUVRIR !
AT TENTION: SUPERFICIE DE CHASSIS CHAUDE