THE SOUND THAT CREATES LEGENDS ‘63 Vibroverb , Owner s Manual P/N 037307
INTRODUCTION Your “new” ‘63 VIBROVERB amplifier is living proof of the quality and longevity of Fender amplifier designs. Fender first introduced the VIBROVERB in the early part of 1963. Unlike many of the other Fender amplifiers that were produced for years, this version of the VIBROVERB had a production life of less than 4 months. It is estimated that fewer than 600 VIBROVERB units were ever produced.
‘63 VIBROVERB FRONT PANEL FUNCTIONS A,B. NORMAL CHANNEL INPUTS - Plug-in connection for H. BRIGHT CHANNEL VOLUME CONTROL - Adjusts the instruments. Input 1 provides 6 dB more gain that overall loudness of the BRIGHT CHANNEL. input 2. The NORMAL CHANNEL is affected by the VIBRATO feature only. The REVERB feature does not I. affect the NORMAL CHANNEL. C. NORMAL CHANNEL VOLUME CONTROL - Adjusts the quency boost or cut in the BRIGHT CHANNEL. J. overall loudness of the NORMAL CHANNEL. D.
M. VIBRATO INTENSITY CONTROL - Adjusts the intensity N. PILOT LAMP - When the lamp is illuminated, the ‘63 of the VIBRATO feature. Turning the control full VIBROVERB is receiving power. Should the lamp burn counter-clockwise turns the VIBRATO feature off. The out, turn off the power, unscrew the red jewel and VIBRATO feature can also be turned on and off using replace the lamp with a type T47 light bulb. the footswitch. ‘63 VIBROVERB FOOTSWITCH FUNCTIONS A.
270W ‘63 VIBROVERB REAR PANEL FUNCTIONS A. FUSE - The fuse is in the AC supply of the amplifier E. MAIN SPEAKER JACK - Plug-in connection for speak- and will help to protect the amplifier and operator in ers. This jack must always be used as the primary the event of an electrical fault. If a fuse blows, it connection to speakers. should only be replaced with a fuse in accordance with the listing at the fuse holder. If the amplifier F.
LINE CORD TOLEX COVERING CARE Your amplifier is equipped with a grounding type supply The exclusive Fender Tolex covering on your cabinet is of cord to reduce the possibility of shock due to electrical fault. the same material that was used on the original Be sure to connect it to a grounded receptacle. DO NOT VIBROVERB. A very light soapy solution on a sponge may ALTER THE AC PLUG. be used to remove dirt and residue that may accumulate in the grain.
‘63 VIBROVERB SPECIFICATIONS PART NUMBER: 120V 100V 230V 230V UK 230V NORDIC 240V AUSTRALIA 21-7200 21-7270 21-7260 21-7240 21-7280 21-7230 DIMENSIONS: Height:19-3/8” (49.2 cm). Width:25” (63.5 cm). Depth:8-5/8” (21.9 cm). WEIGHT: 46lbs (21kg). POWER OUTPUT: 40 watts R.M.S. minimum into 4 ohms. OUTPUT IMPEDANCE: 4 ohms. INPUT IMPEDANCE: Input 1, both channels: 1M ohms. Input 2, both channels: 136k ohms. FEATURES: Tube generated power amp Vibrato in both channels, Reverb in the Bright Channel.