User's Manual

2
XDMA760BT
REMOVAL
KEYS
HEAD UNIT
MOUNTING SLEEVE
OPTIONAL REAR
MOUNTING SUPPORT
BLUE
BLACK
RED
YELLOW
RemoteTurn-On
Conn ect to amplifier or power
antenna. Insulate wire if not used.
Ground
Conn ect to the vehicle
chassis ground.
Accessory
Conn ect to an existing ignition
circuit or switched 12 volt source.
Memory
Conn ect to the battery
circuit or constant 12 volt source.
Right Front
Gray/Black (-)
Gray (+)
Left Front
White/Black (-)
White (+)
Left Rear
Green/Black (-)
Green (+)
Right Rear
Violet/Black (-)
Violet (+)
SUBREARFRONT
L-CH
R-CH
Antenna
Connector
Rear Output
Front Output
Subwoofer Output
Steering Wheel
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
• Remove trim ring from unit.
• Remove 2 transit screws located on top of the unit.
• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting
sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold
separately).
• Test for correct operation and slide into mounting sleeve to secure.
• Snap trim ring into place.
Preparation
TYPICAL DIN FRONT-LOAD MOUNTING METHOD