User Manual

INSTALLATION INSTRUCTIONS
POWER
To power the unit, extend the red wire to a 12v (+) post.
Extend the black wire to the ground post.
SPEAKER CONNECTION
Connect the speaker(s) to the corresponding output
(dependant on the siren model as shown below):
• Storm Pro 100w
• Outputs L & M
• Storm Pro 200w
• Outputs W & X (not polarity dependant)
• Outputs U & V (not polarity dependant)
Speaker outputs are not polarity dependant.
SIREN TONE ACTIVATION
To activate siren tones, apply power to the corresponding
input (dependant on siren model as shown below:
• Storm Pro 100w
• Inputs C, D, E, & F
• Storm Pro 200w
• Inputs C, D, E, F, G, & H for speaker #1
• Inputs I, J, K, L, M, & N for speaker #2
SIREN TONE SELECTION
To cycle through tones activate desired port and
momentarily press the tone selector switch to cycle to
next tone.
IMPORTANT
If your Storm Pro Siren has the label/logo pictured,
it is NOT COMPATIBLE with 4200 DataLink.
DO NOT CONNECT IT via RJ45 to the 4200 System.
Tone Select Button
SIREN TONES
1) Wail 13) Ecto Siren
2) Yelp 14) Bad Boys
3) Fast Yelp 15) Move Out of the Way
4) Phaser 16) Pull Over
5) Mechanical 17) Step Out of the Vehicle
6) Manual Wail 18) Step Out w/Hands Up
7) Hi/Lo 19) Remain in your Vehicle
8) P-Call [Slow] 20) Remain... Windows Down
9) P-Call [Fast] 21) Test Tone
10) Horn & Phaser 22) Italian Police*
11) Horn & Yelp 23) Italian Ambulance*
12) Phaser & Yelp
*Storm Pro 100w Only
For a single speaker, an activated tone with a higher input
number overrides an activated tone with a lower input number.
For example, if Tone 4 and Tone 3 are both activated for
Speaker 1, the siren will play Tone 4 for Speaker 1.
AUDIO TONES
Ectosiren Siren Tone
Bad Boys Song
Move Out of the Way Voice Command
Pull Over Voice Command
Step Out of the Vehicle Voice Command
Step Out Hands Up Voice Command
Remain in Your Vehicle Voice Command
Remain in Vehicle... Windows Down Voice Command
FENIEX // 2018 // INSTRUCTION MANUAL // v2.0
WEB // www.feniexindustries.com
6
TM