User Manual
CONFIGURATION INSTRUCTIONS
POWER
To power the unit, extend the red wire to a 12v (+) post.
Extend the black wire to the ground post.
LATCHING OR MOMENTARY BUTTONS
1)
2) Press and hold the desired button you wish to program
as momentary.
3) Continue holding the selected button while holding
when programmed.
4) The button is now set as a momentary button. To
reverse the function, repeat the steps above.
Only the buttons highlighted in red (above) can be programmed.
1 2 3
4 5 6
1 2
3 4
5 6
ACTIVATING FLASHER FUNCTIONALITY
1)
2) Press and hold buttons 1 and 2 simultaneously.
3) Continue holding buttons 1 and 2 while holding down
programmed.
4)
wag and the button 2 as the pattern select.
To reverse the functionality, repeat the steps above.
POWER-UP FUNCTIONALITY
Auto Power-Up: Keypad activates upon starting vehicle
Manual Power-Up:
activated using power button.
To use this functionality, the Red Wire must be connected to an
ignition switched circuit capable of providing current for all 6
outputs and the siren amplier.
1)
2) Press and hold the power button for 3 seconds. A beep
will sound when programmed.
3)
To reverse the functionality, repeat the steps above.
POSITION FUNCTION ACTIVATION
OFF N/A
M1 Ramp Up/Down Manual [Momentary]
M2 Ramp Up/Stop Manual [Momentary]
HF Continuous Manual x1 & Manual x2
T1 Continuous Manual to switch tones
T2 Continuous Manual to switch tones
T3 Continuous Manual to switch tones
FENIEX // 2019 // INSTRUCTION MANUAL // v2.2
WEB // www.feniexindustries.com
6
TM