User Manual

MOUNTING INSTRUCTIONS
TYPHOON AMPLIFIER MOUNTING
1) Place the unit against the intended mounting surface.
2) Mark the areas where the mounting holes will be drilled.
If the mounting surface is part of the vehicle, make sure
no vital components could be damaged by the drilling
process.
3) Pre-drill four 1/16" mounting holes on the mounting
surface, making sure no vital components of the surface
are damaged.
4) Make sure to deburr the holes thoroughly.



TYPHOON HANDHELD MOUNTING
1) Place the Handheld nest against the intended mounting
surface.
2) Mark the areas where the mounting holes will be drilled.
Ifthe mounting surface is part of the vehicle, make sure
no vital components could be damaged by the drilling
process.
3) Drill two 0.16" mounting holes on the mounting surface,
making sure no vital components of the surface are
damaged.
4) Using customer provided screws, secure the Typhoon
Siren to the mounting surface.
1 ¾"
0.16"
5) Place the Typhoon Handheld Controller into the clip to
hold the unit when not in use.
FENIEX // 2019 // INSTRUCTION MANUAL // v2.2
WEB // www.feniexindustries.com
8
TM